DIY ~ A plywood cover for my Nanuk DSLR & Lens Case–Progress Report, 01/05

Good progress today, after an early morning dental cleaning.

The case before the DIY cover [above].

Man! The cutting was tedious. The flash cutout required the most resizing; therefore, cut, check for ease of insertion and removal. and then cut again. The iPhone slot also took several iterations to get the right size. The board fittingĀ and cutting the 4-corners and not having it loose took special care. The easiest was the hole for the shutter transmitter [in the center]. I did not short-cut or eliminate any devices that were there before. I am glad I do not have to do this again…

This slideshow requires JavaScript.